Short answer. FRP poles are chosen where the pole must not rust, conduct or block radio signals: telecom and antenna masts, lighting, flag and telescoping poles. Give the load and wind case, the length and taper, and any insulation or RF requirement when asking for a quote.
| Pole use | Key requirements | Why FRP |
|---|---|---|
| Telecom, antenna and small-cell poles | Wind and antenna load, deflection, RF transparency, height | Non-conductive and transparent to radio signals; no rust |
| Lighting poles | Luminaire weight and wind load, base fixing, cable entry | Does not corrode; light to install; insulated |
| Flagpoles | Height, wind, halyard fittings, finish and colour | Weather resistant; can be coloured (e.g. black) |
| Telescoping poles and masts | Diameter steps, clearance between sections, locking | Light, non-conductive for work near power lines |
| Utility and warning posts | Visibility, impact, burial depth | Does not rot, flexes on impact |
What to give the manufacturer
- Height above ground and above-ground / buried length.
- Loads: antennas or luminaires (weight, area), wind speed, ice, and the deflection limit.
- Section: single tube or tapered/telescopic, outside diameter, wall thickness.
- Environment: UV, coastal salt, temperature, fire requirement.
- Finish and colour, and the top and base fittings.
Design notes
- Poles are deflection-governed: check sway under wind at the working load before checking strength.
- Tubes are stiffer in bending for the same weight than solid rod; see FRP round tube section properties.
- A black or dark colour absorbs more heat; ask about the resin and UV protection for sunny sites.
- Radio-frequency use: avoid metallic fittings or paint in the antenna field.
Choosing a resin for the site: FRP resin guide. If you need a custom size, start with what we need to quote a custom profile.
Common questions
Frequently asked questions
Can an FRP pole carry the same antenna load as steel?
It can if designed for it, but it deflects more. Define the wind load and the allowed sway, and check the section.
How are poles joined?
Telescopic overlaps, sleeve joints or flanges; the maker designs the splice for the load. Do not field-drill without guidance.
Send us your requirement
Guangdong Haikuo Composite Materials Co., Ltd. (Huizhou, Guangdong) designs pultrusion moulds in-house and produces custom FRP profiles. Send a drawing, a sample or just the application and the environment, and we will tell you what is feasible.
Email: [email protected] | WhatsApp: +86 189 5198 8522